钱怡君,于浩,程兆虎.高强度轮毂的化学成分和熔炼处理工艺的研究[J].精密成形工程,2011,3(5):17-20.
QIAN Yi-jun,YU Hao,CHENG Zhao-hu.The Study of the Chemical Composition of High-strength Hub and Treatment Process of Melting[J].Journal of Netshape Forming Engineering,2011,3(5):17-20. |
| 高强度轮毂的化学成分和熔炼处理工艺的研究 |
| The Study of the Chemical Composition of High-strength Hub and Treatment Process of Melting |
| 投稿时间：2011-03-07 修订日期：2011-09-10 |
| DOI： |
| 中文关键词: 轮毂 铸态铁素体球墨铸铁 化学成分 稀土镁合金 球化处理 孕育处理 |
| 英文关键词: hub as-cast ferrite spheroidal graphite iron chemical composition rare-earth magnesium alloy spheroidization inoculation |
| 基金项目: |
|
| 摘要点击次数: 4244 |
| 全文下载次数: 3241 |
| 中文摘要: |
| 分析了轮毂的工作条件和基本性能要求，从保证其有良好强度和塑性韧性方面，采用强韧性较好的铸态铁素体球墨铸铁制造。对轮毂的化学成分进行设计，确定了其化学成分范围。选用低稀土镁合金的球化剂Re3Mg8，并采用冲入法进行球化处理，同时采用多次孕育处理及增加终硅量，强化孕育效果，使球墨铸铁的强度和塑性韧性得到提高。 |
| 英文摘要: |
| The wheel hub working conditions and the basic performance requirements were analyzed. From the guarantee of its good strength and good toughness and plasticity, it was usually manufactured of as-cast ferrite spheroidal graphite iron with better strength and toughness. From the analysis of chemical composition, the chemical constituents were adjusted. Low-rare-earth magnesium alloy nodularizer Re3Mg8 was chosen, and pouring process was adopted to add spheroidal agents. By adopting effective multiple inoculants, increasing final silicon content and strengthening the inoculation effect, the toughness and plasticity of spheroidal graphite iron were improved. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
渝公网安备 50010702501719号