姜楠,李京龙,熊江涛,等.2524同质铝合金回填式搅拌摩擦点焊耐蚀性研究[J].精密成形工程,2019,11(6):53-58.
JIANG Nan,LI Jing-long,XIONG Jiang-tao,et al.Corrosion Resistance of 2524 Similar Aluminum Alloy Welded by Refilling Friction Stir Spot Welding[J].Journal of Netshape Forming Engineering,2019,11(6):53-58. |
| 2524同质铝合金回填式搅拌摩擦点焊耐蚀性研究 |
| Corrosion Resistance of 2524 Similar Aluminum Alloy Welded by Refilling Friction Stir Spot Welding |
| 投稿时间：2019-08-29 修订日期：2019-11-10 |
| DOI：10.3969/j.issn.1674-6457.2019.06.009 |
| 中文关键词: 2524铝合金 回填式搅拌摩擦点焊 腐蚀 |
| 英文关键词: 2524 aluminum alloy refilling friction stir spot welding corrosion |
| 基金项目: |
|
| 摘要点击次数: 2702 |
| 全文下载次数: 1907 |
| 中文摘要: |
| 目的 研究2524铝合金回填式搅拌摩擦点焊接头不同焊接区域的耐腐蚀性能。方法 采用晶间腐蚀实验结合电子扫描显微镜（SEM）及能谱仪（EDS）技术，分析了焊缝处不同区域的微观形貌、腐蚀形貌及腐蚀深度，并对腐蚀机理进行了讨论。结果 搅拌区内的晶粒最为细小，热影响区的晶粒尺寸最大。搅拌区主要为点蚀，最大腐蚀坑深度为2.45 μm；热影响区则发生剥落腐蚀，最大腐蚀深度为45.65 μm。结论 热影响区的耐蚀性最差，腐蚀程度最为严重。 |
| 英文摘要: |
| The paper aims to study the corrosion resistance of 2524 aluminum alloy refilling friction stir spot welding joints in different welding regions. Combined with scanning electron microscopy (SEM) and energy dispersive spectroscopy (EDS) techniques, the microstructure, corrosion morphology and corrosion depth of different weld regions of the joint were analyzed, and the corrosion mechanism was discussed. The results showed that the grain size in the stirring zone (SZ) was the smallest, while that in the heat-affected zone (HAZ) was the largest. In the SZ, the corrosion was pits, and the maximum depth of the pit was 2.45 μm. Severe exfoliation corrosion occurred in the HAZ. The maximum corrosion depth was 45.65 μm. The HAZ exhibits the worst corrosion resistance and the most severe corrosion. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
渝公网安备 50010702501719号