於伟杰,王匀,尹研,等.薄壁钢筒温成形模具磨损规律及机理[J].精密成形工程,2017,9(4):96-100.
YU Wei-jie,WANG Yun,YIN Yan,et al.Wear Law and Mechanism of Warm Forming Die for Thin-wall Steel Tube[J].Journal of Netshape Forming Engineering,2017,9(4):96-100. |
| 薄壁钢筒温成形模具磨损规律及机理 |
| Wear Law and Mechanism of Warm Forming Die for Thin-wall Steel Tube |
| 投稿时间：2017-05-05 修订日期：2017-07-10 |
| DOI：10.3969/j.issn.1674-6457.2017.04.017 |
| 中文关键词: 薄壁钢筒 温挤压 模具磨损 |
| 英文关键词: thin-wall steel tube warm extrusion die wear |
| 基金项目:国家自然科学基金（51575245）；江苏省重点研发计划（BE2015134）；江苏高校优势学科建设工程；江苏高校品牌专业建设工程（PPZY2015B122） |
|
| 摘要点击次数: 3955 |
| 全文下载次数: 3286 |
| 中文摘要: |
| 目的 通过对薄壁钢筒温成形过程进行数值模拟，分析其磨损规律及机理。方法 采用Deform-3D对薄壁钢筒的温挤压过程进行模拟，分析在不同挤压速度和模具预热温度下，模具最大磨损量的分布规律。结果 挤压速度越小，凸模顶端温度越高，磨损越严重；模具预热温度高于250 ℃时，模具表面氧化膜破坏，模具钢硬度急剧下降，模具磨损加剧。结论 通过设置合理的工艺参数，可以减缓模具的磨损，并为模具表面修复提供了理论依据。 |
| 英文摘要: |
| The paper aims to analyze the wear law and mechanism of thin-walled steel tube by numerical simulation. Deform-3D was used to simulate the warm extrusion process of thin-wall steel tube. The distribution law of the maximum wear amount of mold at different extrusion speed and mold preheating temperature was analyzed. The smaller the extrusion speed was, the higher the punch's tip temperature was, and the more serious the wear was. When the temperature of the die was higher than 250 ℃, the oxidation film on the die surface was damaged, the hardness of the die was decreased and the wear of the die was increased. Setting reasonable process parameters can slow down the mold wear and provide theoretical basis for die repair. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
渝公网安备 50010702501719号