徐龙,束飞,龚甘霖,等.复杂钣金零件充液拉深工艺分析与试验研究[J].精密成形工程,2016,8(6):49-53.
XU Long,SHU Fei,GONG Gan-lin,et al.Process Analysis and Experimental Investigation on Hydroforming of the Complex Sheet Metal Parts[J].Journal of Netshape Forming Engineering,2016,8(6):49-53. |
| 复杂钣金零件充液拉深工艺分析与试验研究 |
| Process Analysis and Experimental Investigation on Hydroforming of the Complex Sheet Metal Parts |
| 投稿时间：2016-09-18 修订日期：2016-11-10 |
| DOI：10.3969/j.issn.1674-6457.2016.06.009 |
| 中文关键词: 充液成形 复杂钣金零件 破裂 起皱 反胀压力 最大液室压力 |
| 英文关键词: hydroforming complex sheet metal parts fracture wrinkle initial inverse pressure full pressure |
| 基金项目:中航工业江西洪都航空工业集团有限责任公司科研项目 |
|
| 摘要点击次数: 3531 |
| 全文下载次数: 3436 |
| 中文摘要: |
| 目的 研究复杂钣金零件充液拉深的成形性能，以代替传统的落压成形工艺。 方法 采用有限元方法对成形过程进行模拟，分析各工艺参数对零件成形质量的影响，以及起皱、破裂等缺陷出现的原因和避免方法，并获得合理的工艺参数范围。以仿真结果为依据，设置工艺试验的初始参数，对该复杂钣金零件进行充液成形试验，以验证工艺可行性。 结果 有限元仿真对成形过程中的起皱和破裂缺陷预测准确，并给出了可行的工艺参数范围；通过成形试验，验证了工艺参数的合理性，获得了合格零件。 结论 充液拉深工艺可以明显改进零件的成形性能，反胀压力、最大液室压力等是充液拉深工艺的重要参数，直接影响着充液拉深过程的成败。 |
| 英文摘要: |
| The work aims to research the hydroforming process of the complex sheet metal parts to replace the traditional stamping process. The hydroforming process of the parts was simulated by the finite element method (FEM) to analyze the influence of all process parameters on the parts and the causes & avoiding methods of the wrinkles and fractures incurred, and obtain the reasonable range of the process parameters. Based on the simulation results, the initial parameters of the process test were set. The hydroforming experiments were conducted to verify the feasibility of the hydroforming process. The defects of wrinkles and fractures were accurately predicted through finite element simulation and the range of feasible process parameters was given. Through the hydroforming experiments, the rationality of process parameters was verified and the qualified parts were obtained. In conclusion, hydroforming can obviously improve the forming performance of the parts. The initial inverse pressure and the full pressure, are the important parameters of hydroforming that directly affect results of the hydroforming process. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
渝公网安备 50010702501719号