文章摘要
王姝俨,夏华,秦梁杰,等.方形孔轴套冷挤压成形工艺研究及数值模拟分析[J].精密成形工程,2016,8(2):47-49,75.
WANG Shu-yan,XIA Hua,QIN Liang-jie,et al.Technology and Numerical Simulation of Cold Extruded Square-hole Shaft Sleeve[J].Journal of Netshape Forming Engineering,2016,8(2):47-49,75.
方形孔轴套冷挤压成形工艺研究及数值模拟分析
Technology and Numerical Simulation of Cold Extruded Square-hole Shaft Sleeve
投稿时间:2015-12-21  修订日期:2016-03-10
DOI:10.3969/j.issn.1674-6457.2016.02.010
中文关键词: 方形孔轴套  冷挤压  数值模拟  塑性成形
英文关键词: special-shaped shaft sleeve  cold extrunded numerical simulation  top die forming load
基金项目:
作者单位
王姝俨 重庆理工大学重庆 400054 
夏华 重庆理工大学重庆 400054 
秦梁杰 重庆理工大学重庆 400054 
胡冬 重庆理工大学重庆 400054 
朱雄 重庆理工大学重庆 400054 
摘要点击次数: 3741
全文下载次数: 3130
中文摘要:
      目的 通过对方形孔轴套的分析, 确定冷挤压工艺成形方形孔轴套的可行性, 为方形孔轴套的实际生产提供理论依据和支持。方法 结合Deform软件, 对方形孔轴套的挤压成形过程进行了数值模拟, 重点分析了零件在冷挤压成形过程中的应力场、 应变场的变化情况。结果 通过模拟得出, 在成形难度大的区域没有出现折叠和破裂缺陷。结论 确定了冷挤压工艺成形方形孔轴套的可行性。
英文摘要:
      The aim of this study is to analysis the difficulty of forming the square-hole shaft sleeve, determine the feasibility of using forming the square-hole shaft sleeve of the cold extrusion technology,and provide the theory basis and the support for the practical production of it. The method of that was doing the extrusion process numerical simulation with DEFORM software. Focus on the analysis the change of stress field,strain field of the components in the preforming process. The result of that there was no folding and cracking did not appear in the molding difficult area by simulating The influences of that was finding the feasibility of using forming the square-hole shaft sleeve of the cold extrusion technology
查看全文   查看/发表评论  下载PDF阅读器
关闭

关于我们 | 联系我们 | 投诉建议 | 隐私保护 | 用户协议

您是第12074305位访问者    渝ICP备15012534号-6

>版权所有:《精密成形工程》编辑部 2014 All Rights Reserved

>邮编:400039 电话:023-68679125传真:02368792396 Email: jmcxgc@163.com

>    

渝公网安备 50010702501719号