陈锴,颜银标,徐跃,等.基于Deform的铝合金薄壁锥形件成形分析[J].精密成形工程,2016,8(1):63-66.
CHEN Kai,YAN Yin-biao,XU Yue,et al.Analysis of Extrusion Forming of Aluminum Alloy Cone Component Based on Deform[J].Journal of Netshape Forming Engineering,2016,8(1):63-66. |
| 基于Deform的铝合金薄壁锥形件成形分析 |
| Analysis of Extrusion Forming of Aluminum Alloy Cone Component Based on Deform |
| 投稿时间：2015-11-20 修订日期：2016-01-10 |
| DOI：10.3969/j.issn.1674-6457.2016.01.012 |
| 中文关键词: Deform-3D 有限元模拟 铝合金 挤压成形 |
| 英文关键词: Deform-3D FEM aluminum alloy extrusion forming |
| 基金项目:国家部委基金资助项目 （C182100C001） |
|
| 摘要点击次数: 3853 |
| 全文下载次数: 3417 |
| 中文摘要: |
| 目的 某锥形薄壁零件服役条件恶劣， 对其性能要求较高。针对其成形， 设计用热挤压的方法代替传统工艺， 提高零件使用性能和生产效率。方法 基于Deform-3D软件平台， 对挤压过程进行了数值模拟， 对不同方案的上模载荷-行程曲线和坯料等效应变分布进行了分析比较。结果 结果表明方案1成形效果更优。结论 最终经实验试制证明了方案切实可行， 为实际生产提供了理论指导。 |
| 英文摘要: |
| The property requirements of a cone component with thin wall and centrosymmetric structure are high because of poor working conditions. In order to improve usability and production efficiency， extrusion was designed to replace traditional forming process. The extrusion programs were simulated based on the Deform-3D software. Load-stroke curves of the top die and Effective strain distribution of the blank for two schemes were analyzed and compared. The conclusion is that the scheme 1 is better. At last， the extrusion program is feasible to form cone component by practicable production. The results provided theoretical guidance for practical production. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
渝公网安备 50010702501719号