付泽,鄂大辛.DP600弯曲变形滞后回弹试验及有限元探究[J].精密成形工程,2016,8(1):59-62,100.
FU Ze,E Da-xin.Time-dependent Springback Tests and the Finite Element Exploration of DP600 after Bending[J].Journal of Netshape Forming Engineering,2016,8(1):59-62,100. |
| DP600弯曲变形滞后回弹试验及有限元探究 |
| Time-dependent Springback Tests and the Finite Element Exploration of DP600 after Bending |
| 投稿时间：2015-11-15 修订日期：2016-01-10 |
| DOI：10.3969/j.issn.1674-6457.2016.01.011 |
| 中文关键词: AZ31镁合金 显微组织 力学性能 |
| 英文关键词: DP600,time-dependent springback the finite element analysis residual stress |
| 基金项目:国家自然科学基金项目 （51175044） |
|
| 摘要点击次数: 3648 |
| 全文下载次数: 3992 |
| 中文摘要: |
| 目的 初步探索室温下板材弯曲滞后回弹的变化规律及产生原因。方法 对DP600高强度钢板进行不同弯曲角的三点弯曲试验， 在室温下测量卸载瞬时回弹及长达1个月的滞后回弹， 同时应用ABAQUS软件中的蠕变模型类比进行有限元分析。 结果 滞后回弹角随时间大致呈指数规律增长， 最后逐渐趋于稳定。在原有蠕变模型基础上引入一个修正系数 k， 改进模型的计算结果与实验值吻合较好； 滞后回弹过程中板材内应力分布逐渐趋于平缓。结论 残余应力的释放是驱动滞后回弹的一种原因。 |
| 英文摘要: |
| To initially explore the time-dependent springback change law and reason of the blank at temperature. Different bending angels of three-point bending tests were taken of high strength steel sheet DP600，then the instantaneous springback angels and time-dependent springback angels for up to a mouth were measured at room temperature，meanwhile the finite element analogy analysis was proceeded with creep model of ABAQUS software. Time-dependent springback angels changed in a exponential growth law over time and finally trended to be stable. The correction coefficient k was introduced to the original creep model， the calculation result of the update model has good agreement with the experimental values. Stress distribution in the plate gradually flattened out. The release of residual stress is one kind of causes of the time-dependent springback. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
渝公网安备 50010702501719号