郭禅,郎利辉,杨希英,等.铝合金 2A16 板材成形极限研究[J].精密成形工程,2015,7(4):76-79,83.
GUO Chan,LANG Li-hui,YANG Xi-ying,et al.Forming Limit of Aluminum Alloy 2A16[J].Journal of Netshape Forming Engineering,2015,7(4):76-79,83. |
| 铝合金 2A16 板材成形极限研究 |
| Forming Limit of Aluminum Alloy 2A16 |
| 投稿时间：2015-05-28 修订日期：2015-07-10 |
| DOI：10.3969/j.issn.1674-6457.2015.04.016 |
| 中文关键词: 铝合金 成形极限 椭圆液压胀形 预测模型 |
| 英文关键词: aluminum alloy forming limit elliptic hydraulic bulging prediction model |
| 基金项目:国家自然科学基金资助项目(51175024) |
|
| 摘要点击次数: 3948 |
| 全文下载次数: 3375 |
| 中文摘要: |
| 目的 掌握硬铝合金在温热条件下的成形性能变化规律。 方法 采用结合半球凸模胀形和椭圆液压胀形的复合试验法进行了 FLD 试验,用最小二乘法拟合试验数据,建立了成形极限预测模型。 结果 试样均在凸模顶端或附近发生破裂,在室温下网格保持较小的圆形,在 210 ℃ 和 300℃下网格被不同程度的拉长和变大,温度对铝合金 2A16 的成形性能影响很大,随温度升高,成形极限曲线上℃。 结论 复合胀形试验法具有较高的可靠性与准确性;铝合金 2A16 在高温下成形性能更好;预测模型较好地表述了极限应变值与温度的关系,根据模型可快速得出 FLD。 |
| 英文摘要: |
| This research aimed to learn the changing law of formability of aluminum alloy under warm/ hot environment. In this research, the FLD test by a method combined of rigid punch bulging and hydraulic bulging was conducted, then the prediction model of forming limit was established using the least square method. The results showed that the fracture points were on or near the top of the specimens, the grids remained small under the room temperature while they became bigger and longer under 210 ℃ and 300 ℃, indicating the temperature had huge influence on the formability of aluminum alloy 2A16 that the curve of forming limit was shifted upward with the increase of temperature. The compound bulging method for test had high reliability and accuracy which revealed that aluminum alloy 2A16 had greater formability under high temperatures. The prediction model well described the relationship between the limit stain and the temperature,and FLD can be quickly gained using this prediction model. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
|
|
|
渝公网安备 50010702501719号