赵玲杰,张驰,汪舜,等.基于数值模拟的 AZ61 镁合金挤压-剪切工艺[J].精密成形工程,2015,7(4):62-65.
ZHAO Ling-jie,ZHANG Chi,WANG Shun,et al.Extrusion-shearing Process of AZ61 Magnesium Alloy Based on Numerical Simulation[J].Journal of Netshape Forming Engineering,2015,7(4):62-65. |
| 基于数值模拟的 AZ61 镁合金挤压-剪切工艺 |
| Extrusion-shearing Process of AZ61 Magnesium Alloy Based on Numerical Simulation |
| 投稿时间：2015-04-21 修订日期：2015-07-10 |
| DOI：10.3969/j.issn.1674-6457.2015.04.013 |
| 中文关键词: 挤压-剪切工艺 有限元模拟 AZ61 镁合金 |
| 英文关键词: extrusion-shearing process finite element simulation AZ61 magnesium alloy |
| 基金项目:重庆市重庆理工大学研究生创新基金项目(YCX2014214) |
|
| 摘要点击次数: 3851 |
| 全文下载次数: 3337 |
| 中文摘要: |
| 目的 研究挤压-剪切变形的最优化工艺参数,分析各个工艺参数对 AZ61 镁合金微观组织和力学性能的影响。 方法 通过有限元模拟技术,分析了各个工艺参数,包括挤压温度、挤压速度、挤压比对 AZ61 镁合金成形结果的影响。 结果 通过对有限元模拟结果的分析和研究,得到AZ61 镁合金成形的最佳工艺参数为:挤压温度为 400 ℃ ;挤压速度为 10 mm/ s;挤压比越大,再结晶效果越明显,晶粒尺寸越细小。 结论 优化了挤压温度、挤压速度、挤压比等影响 AZ61 镁合金成形的因子,得到了符合实际生产的最佳工艺参数。 |
| 英文摘要: |
| The aim of this study was to investigate optimization of forming process parameters of the extrusion-shear deformation, and to analyze the influence of process parameters on the microstructure of AZ61 magnesium alloy and the mechanical properties. The influence of process parameters were analyzed including extrusion temperature, extrusion speed and extrusion ratio on the results of AZ61 magnesium alloy forming by finite element simulate. The optimized process parameters of AZ61 magnesium alloy forming through the finite element simulation was as follow: the extrusion temperature was 400 ℃; the extrusion speed was 10mm/ s; with the increase of extrusion ratio, the effect of recrystallization was better and the grain size was smaller. The influencing factors for AZ61 magnesium alloy of extrusion temperature, extrusion speed and extrusion ratio were optimized, and the best process parameters of AZ61 magnesium alloy were obtained. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
|
|
|
渝公网安备 50010702501719号