杜勇,闻瑶,马俊林,等.隔热板冲压成形工艺参数优化[J].精密成形工程,2014,6(5):108-112.
DU Yong,WEN Yao,MA Jun-lin,et al.Optimization of the Process Parameters for Thermal Baffle Stamping Forming[J].Journal of Netshape Forming Engineering,2014,6(5):108-112. |
| 隔热板冲压成形工艺参数优化 |
| Optimization of the Process Parameters for Thermal Baffle Stamping Forming |
| 投稿时间：2014-06-16 修订日期：2014-09-01 |
| DOI：10. 3969 /j. issn. 1674-6457. 2014. 05. 019 |
| 中文关键词: 隔热板 正交优化 数值模拟 |
| 英文关键词: thermal baffle orthogonal experimental optimization numerical simulation |
| 基金项目: |
|
| 摘要点击次数: 4382 |
| 全文下载次数: 3509 |
| 中文摘要: |
| 目 的 确定隔热板合理可行的成形方案。 方法 简 要分析了 零件的 成形特点, 并利 用 有限元软件对零件的拉延成形进行了 数值模拟。 设计正交实验时, 以压边力、1 号和 3 号拉延筋的完全锁模力、2 号和 4 号拉延筋的完全锁模力 及摩擦因 数 4 个参数为 自 变量, 以 最大厚度减薄率、破裂情况以及未充分变形区大小为优化目 标。 结果 2 号和 4 号拉延筋是该隔热板成形的主要影响因素, 锁模力都为 60 N /mm 时, 隔热板拉延成形效果较好。 结论 通过分析各因 素对优化目 标的 影响, 得出 了 优化的工艺参数值, 为零件的实际生产提供指导。 |
| 英文摘要: |
| Objective To determine reasonable and feasible forming solutions. Methods The forming characteristics of the thermal baffle was analyzed, and finite element software was used to conduct numerical simulation for drawing forming of the part. When designing the orthogonal experiment, BHF, full clamping force of 1 and 3 drawbeads, full clamping force of 2 and 4 drawbeads and the friction coefficient were set as the independent variables, and the maximal thickness reduction rate, rupture as well as size of insufficient deformation zone were set as the optimization targets. Results The 2nd and the 4th drawbeads were the main influencing factors of the thermal baffle forming, when both clamping forces were 60 N /mm, the thermal baffle formed better. Conclusion Optimized process parameters were obtained through analysis of the impact of various factors on the optimization targets, which provides guidance for the actual production of the part. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
|
|
|
渝公网安备 50010702501719号