文章摘要
彭颋,聂兰启,葛宝华.油封骨架成形工艺及模具改进[J].精密成形工程,2014,6(4):85-88.
PENG Ting,NIE Lan-qi,GE Bao-hua.Forming Technology and Die Improving of Oil Seal Frame[J].Journal of Netshape Forming Engineering,2014,6(4):85-88.
油封骨架成形工艺及模具改进
Forming Technology and Die Improving of Oil Seal Frame
投稿时间:2014-05-15  修订日期:2014-07-01
DOI:10.3969/j.issn.1674-6457.2014.04.016
中文关键词: 骨架  排样  多工位级进模  冲孔  拉深
英文关键词: frame  layout  multi-position progressive die  punching  drawing
基金项目:
作者单位
彭颋 西南技术工程研究所, 重庆 400039 
聂兰启 山东红旗机电有限公司, 潍坊 261031 
葛宝华 山东红旗机电有限公司, 潍坊 261031 
摘要点击次数: 4254
全文下载次数: 3668
中文摘要:
      目的 解决骨架生产效率低的问题。 方法 基于对原生产工艺的分析,提出了采用多工位级进模工艺生产该零件,同时,对该零件排样设计中遇到的 2 个技术问题提出了解决措施。 结果 经工艺和模具改进后,生产效率得到了大大提高,工人的劳动强度大大降低,满足了大批量生产的要求。 结论 通过采取有效措施,解决了多工位级进模排样,必须先落料后拉深成形的难题,为同类型零件的加工提供了参考。
英文摘要:
      Objective To solve the low production efficiency problem of oil seal frame. Methods Based on the investigation of the original manufacturing process, we proposed a multi-position progressive die to produce this part, meanwhile, two technical problems encountered in layout design were solved. Results The optimized process and dies could improve the production efficiency, reduce the labor intensity and meet the requirements of mass production. Conclusion By taking effective measures, the difficult problem that multi-position progressive die layout must be drawn before blanking was solved, which also provides reference for the production of similar parts.
查看全文   查看/发表评论  下载PDF阅读器
关闭

关于我们 | 联系我们 | 投诉建议 | 隐私保护 | 用户协议

您是第12069042位访问者    渝ICP备15012534号-6

>版权所有:《精密成形工程》编辑部 2014 All Rights Reserved

>邮编:400039 电话:023-68679125传真:02368792396 Email: jmcxgc@163.com

>    

渝公网安备 50010702501719号