文章摘要
闻瑶,甘国强,王成国.基于数值模拟的隔热板零件冲压工艺研究[J].精密成形工程,2014,6(4):41-45.
WEN Yao,GAN Guo-qiang,WANG Cheng-guo.Analysis and Optimization of Thermal Baffle Stamping Process Based on Dynaform[J].Journal of Netshape Forming Engineering,2014,6(4):41-45.
基于数值模拟的隔热板零件冲压工艺研究
Analysis and Optimization of Thermal Baffle Stamping Process Based on Dynaform
投稿时间:2014-03-26  修订日期:2014-07-01
DOI:10.3969/j.issn.1674-6457.2014.04.008
中文关键词: 隔热板  DYNAFORM  数值模拟  正交试验
英文关键词: the thermal baffle  Dynaform  numerical simulation  orthogonal test
基金项目:
作者单位
闻瑶 合肥工业大学 材料科学与工程学院, 合肥 230009 
甘国强 合肥工业大学 材料科学与工程学院, 合肥 230009 
王成国 合肥工业大学 材料科学与工程学院, 合肥 230009 
摘要点击次数: 4604
全文下载次数: 3518
中文摘要:
      目的 研究隔热板零件冲压过程中的最优化成形工艺参数。 方法 利用 Dynaform 软件先对零件模型的成形进行了初步数值分析,根据成形后的成形极限图( FLD) 与厚度分布图,确定了合理的拉延筋分布位置与对应的锁死率;再通过正交试验研究了冲压工艺参数。 结果 得出了压边力、锁模力、板料厚度和摩擦因数对隔热板成形过程中拉裂和起皱趋势的影响规律。 结论 得到了成形过程中合理的成形工艺参数,最大减薄率控制在 22% 以下,未变形区较少。
英文摘要:
      Objective To study the optimization of forming process parameters of insulation board parts. Methods Through the finite element analysis software Dynaform, according to the forming limit diagram ( FLD) and the thickness distribution diagram, the proper draw bead distribution and the corresponding locked rate were determined. Results The influencing rule of stamping process parameters including blank holder force, draw bead locked force and friction coefficient on the cracking and wrinkling tendency were obtained through the orthogonal test. Conclusion The optimized stamping process parameters were summarized. The maximum reduction ratio was controlled to 22% or below, with fewer undeformed zones.
查看全文   查看/发表评论  下载PDF阅读器
关闭

关于我们 | 联系我们 | 投诉建议 | 隐私保护 | 用户协议

您是第12080773位访问者    渝ICP备15012534号-6

>版权所有:《精密成形工程》编辑部 2014 All Rights Reserved

>邮编:400039 电话:023-68679125传真:02368792396 Email: jmcxgc@163.com

>    

渝公网安备 50010702501719号