王震,杨洋.铝合金车轮一次性大减薄率强力旋压模拟与工艺优化[J].精密成形工程,2014,6(3):6-9.
WANG Zhen,YANG Yang.Simulation Research and Process Optimization on Power Spinning of Aluminum Wheel[J].Journal of Netshape Forming Engineering,2014,6(3):6-9. |
| 铝合金车轮一次性大减薄率强力旋压模拟与工艺优化 |
| Simulation Research and Process Optimization on Power Spinning of Aluminum Wheel |
| 投稿时间：2014-03-08 修订日期：2014-05-01 |
| DOI：10.3969/j.issn.1674-6457.2014.03.002 |
| 中文关键词: 铝合金车轮 一次性大减薄率 强力旋压 Simufact 旋轮轨迹 旋轮载荷 |
| 英文关键词: aluminum wheel large thinning ratio one-time power spinning Simufact roller track load of roller |
| 基金项目:河北省自然科学基金( F2013203186) ;河北省高等学校青年基金项目( Q2012044 ) ;燕山大学青年教师自主研究计划课题(13LGA020) |
|
| 摘要点击次数: 4615 |
| 全文下载次数: 3674 |
| 中文摘要: |
| 目的 研究铝合金车轮的一次性大减薄率强力旋压模拟,以及工艺的改善方案。 方法 基于 Simufact 旋压模块,对铝合金车轮的一次性大减薄率强力旋压进行了数值模拟,分析了旋轮的运动轨迹对旋压成形、材料等效应力、旋轮载荷的影响。 结果 通过调整 3 个旋轮的工作轨迹,重新分配每个旋轮的错距、减薄率,控制材料的隆起,解决了折叠、裂纹和设备过载等问题。 结论 实现了铝合金车轮一次性大减薄率旋压成形,一次性减薄率达到 70% 以上。 |
| 英文摘要: |
| Objective To study the simulation and process optimization on power spinning of aluminum wheel. Methods Based on Simufact spinning module,the large thinning ratio in one-time power spinning of aluminum wheel was simulated, the effects of roller track on the shape forming, material equivalent stress and load of roller were analyzed. Results Through readjusting of the track of 3 rollers, the distance and thinning ratio of each roller were redistributed, and material raising was controlled, solving the forming defect such as overlap, crack and overload. Conclusion Large thinning ratio one-time power spinning was achieved, and the thinning ratio of one-time reached over 70% . |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
|
|
|
渝公网安备 50010702501719号