文章摘要
刘海艳,杨健,姜春茂,等.塑料药筒结构设计及吹塑成形工艺[J].精密成形工程,2014,6(2):63-66.
LIU Hai-yan,YANG Jian,JIANG Chun-mao,et al.Structure Design and Molding Process of Plastic Cartridge[J].Journal of Netshape Forming Engineering,2014,6(2):63-66.
塑料药筒结构设计及吹塑成形工艺
Structure Design and Molding Process of Plastic Cartridge
投稿时间:2014-01-16  修订日期:2014-03-01
DOI:10.3969/j.issn.1674-6457.2014.02.013
中文关键词: 塑料药筒  结构设计  成形工艺  性能检测
英文关键词: plastic cartridge case  structural design  molding process  performance testing
基金项目:
作者单位
刘海艳 北方华安工业集团有限公司, 齐齐哈尔 161046 
杨健 北方华安工业集团有限公司, 齐齐哈尔 161046 
姜春茂 北方华安工业集团有限公司, 齐齐哈尔 161046 
娄勇健 北方华安工业集团有限公司, 齐齐哈尔 161046 
张丽娜 北方华安工业集团有限公司, 齐齐哈尔 161046 
周宇杭 北方华安工业集团有限公司, 齐齐哈尔 161046 
摘要点击次数: 4568
全文下载次数: 3546
中文摘要:
      目的 解决药筒在射击后退壳故障问题,降低生产成本。 方法 将钢质药筒改成塑料药筒,并进行了拉伸力学性能检测、合膛性能以及靶场射击试验。 结果 产品通过了相关性能检测,满足使用要求。 结论 全面解决了在高膛压条件下射击时,因金属药筒变形而出现半退壳和不退壳状态的故障问题。
英文摘要:
      Objective To solve the shot ejection failure problem of the cartridge, and to reduce the production cost.Methods The steel cartridge was replaced by plastic cartridge, and tested for tensile mechanical properties, bore performance and shooting range. Result The products passed the relevant performance testing, and met the requirements of use.Conclusion A comprehensive solution was developed for the failure of the ejection and incomplete ejection due to the metal cartridge case deformation under the high chamber pressure conditions during shooting.
查看全文   查看/发表评论  下载PDF阅读器
关闭

关于我们 | 联系我们 | 投诉建议 | 隐私保护 | 用户协议

您是第12080083位访问者    渝ICP备15012534号-6

>版权所有:《精密成形工程》编辑部 2014 All Rights Reserved

>邮编:400039 电话:023-68679125传真:02368792396 Email: jmcxgc@163.com

>    

渝公网安备 50010702501719号