马勇,彭程,桂伟,等.法兰轴热挤压工艺设计及分析[J].精密成形工程,2014,6(2):12-17.
MA Yong,PENG Cheng,GUI Wei,et al.Process Design and Analysis of Hot Extrusion of Flange Shaft[J].Journal of Netshape Forming Engineering,2014,6(2):12-17. |
| 法兰轴热挤压工艺设计及分析 |
| Process Design and Analysis of Hot Extrusion of Flange Shaft |
| 投稿时间：2013-12-12 修订日期：2014-03-01 |
| DOI：10.3969/j.issn.1674-6457.2014.02.003 |
| 中文关键词: 法兰轴 热挤压 工艺设计 数值模拟 |
| 英文关键词: flange shaft hot extrusion process design FEM |
| 基金项目:2011 教育部科学技术研究重大项目(311025) |
|
| 摘要点击次数: 4862 |
| 全文下载次数: 3902 |
| 中文摘要: |
| 目的 以某型号法兰轴为研究对象,为了制取性能和结构合格的法兰轴。 方法 对其进行了结构及加工工艺分析,确定了成形工艺方案为:下料寅正挤轴部寅顶镦头部寅反挤法兰及内腔。根据该工艺,建立了法兰轴的三维模型,利用有限元分析软件对法兰轴的成形缺陷进行了分析,并进行了工艺改进,以获得合格的零件。 结果 改进后的工艺可以制取合格的零件。 结论 此工艺方法对实际生产有指导价值。 |
| 英文摘要: |
| Objective In this paper, the flanged shaft was studied to achieve products with qualified performance and structure. Methods The structure and process were analyzed, and the specific forming process was finalized as cutting, extruding the shaft part, upsetting the head portion, and anti-extrusion of flange and cavity. Based on this process, a threedimensional model was established for the formation of the flanged shaft, and the forming defects of the flanged shaft were analyzed with the FEM software, and then the process optimization was made to achieve qualified products. Results The results showed that qualified products were obtained after process optimization. Conclusion This process can function as valuable guidance for the production practice. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
|
|
|
渝公网安备 50010702501719号