潘利波,胡吟萍,魏星,等.轿车车门内板拉深成形过程的有限元分析[J].精密成形工程,2012,4(4):17-19,68.
PAN Li-bo,HU Ying-ping,WEI Xing,et al.Finite Element Analysis on Deep Drawing Process of Door Inner Panel[J].Journal of Netshape Forming Engineering,2012,4(4):17-19,68. |
| 轿车车门内板拉深成形过程的有限元分析 |
| Finite Element Analysis on Deep Drawing Process of Door Inner Panel |
| 投稿时间：2012-03-24 修订日期：2012-07-10 |
| DOI： |
| 中文关键词: 车门内板 深冲 有限元 PAM-STAMP |
| 英文关键词: door inner panel deep drawing finite element PAM-STAMP |
| 基金项目: |
|
| 摘要点击次数: 3396 |
| 全文下载次数: 2753 |
| 中文摘要: |
| 利用板料成形有限元软件对某轿车车门内板的一次拉深过程进行了数值模拟，分析了其成形过程中的危险区域，并对拉深过程中的缺陷产生原因进行了分析，通过调整工艺参数，得到比较理想的结果，可为该零件实际生产提供参考。 |
| 英文摘要: |
| The one-off deep drawing process for door inner panel of certain car type was numerically modeled and simulated by utilizing commercial code of sheet metal forming. With the appropriate material, the critical forming zones were indicated, and factors which cause defects in the course of drawing were analyzed. The reasonable result was obtained by modulating rational technology parameters, which provides significant reference for practical manufacturing of this part. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
渝公网安备 50010702501719号