文章摘要
神和忠,胡建巧,聂兰启.传动轴冲方凸模的改进[J].精密成形工程,2012,4(1):71-72,81.
SHEN He-zhong,HU Jian-qiao,NIE Lan-qi.Punch Improvement for Square Hole of Transmission Shaft[J].Journal of Netshape Forming Engineering,2012,4(1):71-72,81.
传动轴冲方凸模的改进
Punch Improvement for Square Hole of Transmission Shaft
投稿时间:2011-08-16  修订日期:2012-01-10
DOI:
中文关键词: 传动轴  冲方  凸模
英文关键词: transmission shaft  punching square hole  punch
基金项目:
作者单位
神和忠 山东红旗机电有限公司 山东 潍坊 261031 
胡建巧 山东红旗机电有限公司 山东 潍坊 261031 
聂兰启 山东红旗机电有限公司 山东 潍坊 261031 
摘要点击次数: 3558
全文下载次数: 2786
中文摘要:
      采用冲方加工工艺加工传动轴方孔,由于原冲方凸模端面为平端面,切削力较大,零件的表面粗糙度达不到图纸要求。每加工一件传动轴,需要更换7次冲方凸模和冲方加工7次,生产效率低,劳动强度大。通过改进冲方凸模结构,只需更换4次冲方凸模和冲方加工4次,就能生产出尺寸精度高,表面粗糙度低的传动轴零件,而且提高了生产效率,降低了生产成本。
英文摘要:
      For the flat end face of the original square punch in the punching technology of transmission shaft's square hole, the cutting force is larger. Therefore the surface roughness of the part does not meet the requirements of the drawing. For the processing of each transmission shaft, it is needed to replace square punch seven times and punch seven times, so that production efficiency is low and labor intensity is high. Through improving the square punch structure, it is only needed to replace square punch four times and punch four times. Parts with high precision and low surface roughness can be produced. The production efficiency is improved and the cost of production is reduced.
查看全文   查看/发表评论  下载PDF阅读器
关闭

关于我们 | 联系我们 | 投诉建议 | 隐私保护 | 用户协议

您是第12082299位访问者    渝ICP备15012534号-6

>版权所有:《精密成形工程》编辑部 2014 All Rights Reserved

>邮编:400039 电话:023-68679125传真:02368792396 Email: jmcxgc@163.com

>    

渝公网安备 50010702501719号