文章摘要
汪小霞,纵荣荣,时建松,等.发动机用铝活塞的铸造数值模拟[J].精密成形工程,2010,2(5):78-82.
WANG Xiao-xia,ZONG Rong-rong,SHI Jian-song,et al.Numerical Simulation of Casting of an Aluminum Engine Piston[J].Journal of Netshape Forming Engineering,2010,2(5):78-82.
发动机用铝活塞的铸造数值模拟
Numerical Simulation of Casting of an Aluminum Engine Piston
投稿时间:2010-05-26  修订日期:2010-09-10
DOI:
中文关键词: 铝活塞  保温冒口  充型过程  凝固过程  数值模拟
英文关键词: aluminum alloy piston  insulating riser  filling process  solidification process  numerical simulation
基金项目:
作者单位
汪小霞 合肥工业大学 材料科学与工程学院, 合肥 230009 
纵荣荣 合肥工业大学 材料科学与工程学院, 合肥 230009 
时建松 合肥工业大学 材料科学与工程学院, 合肥 230009 
苏伟 安徽江淮汽车股份有限公司技术中心, 合肥 230022 
摘要点击次数: 3410
全文下载次数: 2930
中文摘要:
      利用ProCAST软件对ZL108活塞零件的传统铸造工艺和改变冒口形状的2种新铸造工艺进行了模拟对比分析,以上小下大的冒口形状新工艺铝活塞效果更好。再对比模拟分析此冒口形状铝活塞在3组不同浇注温度下的充型凝固过程,最终确定保温冒口截面为上小下大和浇注温度为720 ℃是活塞的最佳铸造工艺。
英文摘要:
      The software of ProCAST was used to simulation to comparative analysis of the traditional casting process and two new casting processes by changing the shape of riser of the ZL108 piston. The result showed that it played a good filling effect on the riser with small top and big bottom.Then by comparison to the filling and solidification process for the aluminum piston with this shape of the riser under three groups of different pouring temperatures the piston's best foundry technique was confirmed in which insulating riser's section was with small top and big bottom and the pouring temperature was 720℃.
查看全文   查看/发表评论  下载PDF阅读器
关闭

关于我们 | 联系我们 | 投诉建议 | 隐私保护 | 用户协议

您是第12081985位访问者    渝ICP备15012534号-6

>版权所有:《精密成形工程》编辑部 2014 All Rights Reserved

>邮编:400039 电话:023-68679125传真:02368792396 Email: jmcxgc@163.com

>    

渝公网安备 50010702501719号