文章摘要
蒲思洪,孙莉芳,王龙祥.径-轴双向环轧工艺的研究进展[J].精密成形工程,2010,2(4):43-47,71.
PU Si-hong,SUN Li-fang,WANG Long-xiang.Research Progress in Radial-axial Ring Rolling[J].Journal of Netshape Forming Engineering,2010,2(4):43-47,71.
径-轴双向环轧工艺的研究进展
Research Progress in Radial-axial Ring Rolling
投稿时间:2010-04-13  修订日期:2010-07-10
DOI:
中文关键词: 径-轴双向环轧  理论研究  工艺参数  轧制曲线  数值模拟
英文关键词: Radial-axial ring rolling  theoretic research  process parameters  rolling curve  numerical simulation
基金项目:
作者单位
蒲思洪 贵州安大航空锻造有限责任公司 贵州 安顺 561005 
孙莉芳 贵州安大航空锻造有限责任公司 贵州 安顺 561005 
王龙祥 贵州安大航空锻造有限责任公司 贵州 安顺 561005 
摘要点击次数: 3350
全文下载次数: 2775
中文摘要:
      回顾了环件径-轴双向轧制锻透条件、咬入条件、刚度条件等相关理论研究进展,分析了工艺参数对轧制过程的影响及其确定准则,在此基础上引入轧制曲线的概念,并给出了径-轴双向环轧轧制曲线的设计原则,还探讨了在利用有限元方法模拟轧制过程、优化轧制工艺参数时存在的问题,并给出了对数值模型进行控制和处理的有效方法。
英文摘要:
      The recent theoretic research progress of Radial-axial ring rolling, such as condition of roll deformation across the section of ring, condition of roll bite and condition of ring rigidity, were reviewed in this paper. The effect which caused by process parameters and the design principles of process parameters were analysed. On that basis the concept of rolling curve was introduced, and the design principles of rolling curve of Radial-axial ring rolling was given. The problems which appeared in the process of using finite element method for simulating rolling process and optimizing ring rolling process parameters were discussed, and the effective method for controlling and handling numerical model was given, the researches provided references for choice of rolling process parameters and boundary condition of ring and roll in finite element simulation.
查看全文   查看/发表评论  下载PDF阅读器
关闭

关于我们 | 联系我们 | 投诉建议 | 隐私保护 | 用户协议

您是第12069179位访问者    渝ICP备15012534号-6

>版权所有:《精密成形工程》编辑部 2014 All Rights Reserved

>邮编:400039 电话:023-68679125传真:02368792396 Email: jmcxgc@163.com

>    

渝公网安备 50010702501719号